Davey Speedman Compact Constant Water Pressure Systems User Manual

Please pass these instructions on to the operator of this equipment.Installation andOperating Instructions for Davey Speedman Compact Constant WaterPr

10• Speedman Compact controller will display the pre-set operating pressure.3.5 BarACTIVE ...To check direction of rotation for motor – Note:

11ProtectionShould the Speedman Compact controller detect a system fault it protects the pump by turning it off. Under some of these circumstances, it

12Self Diagnostics DisplayShould the Speedman Compact controller shut down unexpectedly, check the controller screen for fault diagnostics information

13MESSAGE MESSAGE MEANING PUMP STATE WHAT TO DO..STOP CC...• After 10 reset attempts for short circuit ph-ph-gnd of the electropumpOff• For reset

14MESSAGE MESSAGE MEANING PUMP STATE WHAT TO DOImax fault• An excessive amount of electrical current is registered in the pumpOff• Verify that the pum

15WARNING: When servicing or attending pump, always ensure power is switched off and lead unplugged. Electrical connections should be serviced only b

16Davey® Repair or Replacement GuaranteeIn the unlikely event in Australia or New Zealand that this Davey product develops any malfunction within two

2Congratulations on your purchase of a high quality, Davey constant pressure water pressure system. All components have been designed and manufactured

31. Pump Priming Plug2. Speedman Compact Control Module3. Discharge Outlet (11/4” BSPF)4. Suction Inlet (11/4” BSPF)5. Pump Body6. Motor7. Rotar

4The Davey Speedman Compact tted to this pump has a status indicator mounted on its front panel. This will be illuminated whenever the Speedman Compa

5In accordance with AS 3350.2.41 we are obliged to inform you that this appliance is not intended for use by young children or inrm persons unless th

6Installations with ooded suction require a gate or isolating valve so water supply can be turned off for pump removal and servicing.For Automatic Pr

7Priming and Operation1. Remove priming plug and ll casing and suction line (on ooded suction, simply open gate valve to pump). When full, replac

8Changing Pre-setsThe display will scroll through the various settings in order.Choose with + & -Save with ENTERLanguage• Press + or - to change

9System Pressure• Press + or - to change the value (from 1.00 to 7.50). Note: this has been factory set at 2.5 Bar.• Insert the value for desired pr